Husqvarna HU700H 用户手册

•  The grass catcher may be hosed with water, but must 

be dry when used.

•  Check your grass catcher often for damage or de te-

 ri o ra tion.  Through normal use it will wear.  If catcher 

needs replacing, replace only with ap proved replace-

ment catcher.  Give the lawn mower model number 

when ordering.

•  To keep your drive system working properly, the gear 

case and area around the drive should be kept clean 

and free of trash build-up.  Clean under the drive cover 

twice a season.

•  The gear case is filled with lubricant to the proper 

level at the factory.  The only time the lubricant needs 

attention is if service has been performed on the gear 

case.

Maintenance, repair, or replacement of the emission control 

devices and systems, which are being done at the custom-

ers expense, may be performed by any non-road engine 

repair establishment or individual. Warranty repairs must 

be performed by an authorized engine manufacturer’s 

service outlet.

Use only high quality detergent oil rated with API service 

classification SG–SL.  Select the oil's SAE viscosity grade 

according to your expected operating temperature.

NOTE:  Multi-viscosity oils (5W30, 10W30 etc.) improve 

starting in cold weather, and you should check your engine 

oil level frequently to avoid possible engine damage from 

running low on oil.
Change the oil after every 25 hours of operation or at least 

once a year if the lawn mower is not used for 25 hours in 

one year.
Check the crankcase oil level before starting the engine 

and after each five (5) hours of continuous use. Tighten oil 

plug securely each time you check the oil level.

NOTE:  Before tipping lawn mower to drain oil, empty fuel 

tank by running engine until fuel tank is empty.
1.  Disconnect spark plug wire from spark plug and place 

wire where it cannot come in contact with plug.

2.  Remove oil fill cap/dipstick; lay aside on a clean sur-

face.

3.  Tip lawn mower on its side as shown and drain oil into 

a suitable container. Rock lawn mower back and forth 

to remove any oil trapped inside of engine.

4.  Wipe off any spilled oil from lawn mower or side of 

engine.

5.  Fill engine with oil.  Slowly pour oil down the oil fill 

spout into the engine.

6.  Wait one minute to allow oil to settle.  Use guage on 

oil fill cap/dipstick for checking level.  Insert dipstick 

into the tube and rest the oil fill cap on the tube.  DO 

NOT thread the cap into the tube when taking reading.

7.  Continue adding small amounts of oil and recheck-

ing the dipstick until it reads full.  DO NOT overfill, or 

engine will smoke on startup.

8.  Always be sure to retighten oil fill cap/dipstick before 

starting engine.

9.  Reconnect spark plug wire to spark plug.

Your engine will not run properly and may be damaged 

by using a dirty air filter. Replace the air filter every 100 

hours of operation or every season, whichever occurs first.  

Service air cleaner more often under dusty conditions.
TO CLEAN AIR FILTER
1. Remove 

cover.

2.  Carefully remove cartridge.
3.  Clean by gently tapping on a flat surface. If very dirty, 

replace cartridge.