Husqvarna HU700H 用户手册

See “TO ADJUST CUTTING HEIGHT” in the Operation 

section of this manual.

The rear deflector, attached between the rear wheels of 

your mower, is provided to minimize the possibility that 

objects will be thrown out of the rear of the mower into 

the operator's mowing position.  Replace the rear deflec-

tor if damaged.

1.  Remove screws securing rear baffle.
2.  Turn mower on its side with air filter and car bu re tor up.
NOTE:  Before tipping lawn mower to remove drive belt, 

empty fuel tank by running engine until fuel tank is empty.
3.  Remove rear baffle from mower.
4.  Disconnect return spring from rear baffle / rear gearcase 

belt keeper.

5.  Remove blade bolt, lockwasher, hardened washer and 

blade.

6.  Remove debris shield.
7.  Remove gearcase belt keeper.
8.  Remove drive belt.

1.  Place new drive belt on gearcase pulley.
NOTE: Always use factory approved belt to assure proper 

fit and long life.
2.  Reinstall gearcase belt keeper.  Be sure the new drive 

belt is inside the tabs of the gearcase belt keeper. 

3.  Position the blade adapter on the engine crank shaft. 

Be sure key in adapter and crankshaft keyway are 

aligned; and that the new drive belt is inside the tabs 

of the belt retainer.

4.  Reattach return spring to rear baffle / rear gearcase 

belt keeper.

5.  Place rear baffle in mower housing.
6.  Reinstall debris shield.
7.  Reinstall blade.  The recommended tightening torque is 

35–40 ft. lbs. (47–54 Nm).

8.  Return mower to upright po si tion.
9.  Reinstall rear baffle screws.

The handle on your lawn mower has three (3) height posi-

tions - adjust to height that suits you.
1.  Remove knob and carriage bolt on one side of the 

lower handle.

2.  While holding handle assembly, remove knob and 

car riage bolt from opposite side, align hole in handle 

with desired hole in handle bracket and reassemble 

bolt and knob and tighten securely.

3.  Align opposite side of handle with same positioning 

hole and secure with bolt and knob.