Husqvarna HU700H 用户手册

下载
页码 40
16
SERVICE AND ADJUSTMENTS
ENGINE
Maintenance, re pair, or re place ment of the emission con trol 
de vic es and sys tems, which are be ing done at the cus tom-
 ers expense, may be performed by any non-road engine 
repair es tab lish ment or individual. Warranty repairs must 
be performed by an authorized engine man u fac tur er's 
service outlet.
ENGINE SPEED
Your engine speed has been factory set.
STORAGE
Immediately prepare your mower for storage at the end of 
the season or if the unit will not be used for 30 days or more. 
LAWN MOWER
When lawn mower is to be stored for a period of time, clean 
it thoroughly, remove all dirt, grease, leaves, etc.  Store in 
a clean, dry area.
1.  Clean entire lawn mower (See “CLEANING” in the 
Maintenance section of this manual).
2.  Lubricate as shown in the Maintenance section of this 
manual.
3.  Be sure that all nuts, bolts, screws, and pins are se-
curely fastened.  Inspect  moving parts for damage, 
breakage and wear.  Replace if necessary.
4.  Touch up all rusted or chipped paint surfaces; sand 
lightly before painting.
HANDLE (See Figs. 21 and 22)
You can fold your lawn mower han dle for storage.
1.  Loosen the two “star” handle knobs on sides of the 
upper handle and allow handle to fold down to the 
rear.
2.  Loosen the two “standard” handle knobs on sides of 
the lower handle and pivot entire handle as sem bly 
forward and allow it to rest on mower.
3.  Reinstall “standard” knobs and carriage bolts to lower 
handle or handle brackets for safe keeping.
•  When setting up your handle from the storage position, 
you must manually lock lower handle into mowing 
position.
IMPORTANT:  WHEN FOLDING THE HANDLE FOR STORAGE 
OR TRANSPORTATION, BE SURE TO FOLD THE HANDLE AS 
SHOWN OR YOU MAY DAMAGE THE CONTROL CABLES.
CARBURETOR
Your carburetor is not adjustable. 
IMPORTANT:  NEVER TAMPER WITH THE ENGINE GOVERNOR, 
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.  
OVER SPEED ING THE ENGINE ABOVE THE FACTORY HIGH 
SPEED SETTING CAN BE DANGEROUS.  IF YOU THINK THE 
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, 
CONTACT YOUR NEAREST HUSQVARNA OR OTHER 
AUTHORIZED SER VICE CEN TER, WHICH HAS PROPER 
EQUIP MENT AND EXPERIENCE TO MAKE ANY NEC ES SARY 
ADJUSTMENTS. 
FIG. 22
HANDLE
BRACKET
BOLT
KNOB
FIG. 21
MOWING
POSITION
OPERATOR 
PRES ENCE
CONTROL 
BAR
FOLD
FORWARD
FOR
STORAGE
LOWER 
HANDLE
UPPER 
HANDLE 
“STAR” 
KNOB
LOWER HANDLE 
“STANDARD” KNOB
UPPER 
HANDLE