Husqvarna P 520D 用户手册
English
– 35
Lubrication
The drive shaft front support
bearing
bearing
Lubricate with a grease gun until the grease is forced out.
The drive shaft rear support bearing
2 grease nipples. Lubricate with a grease gun until the grease
is forced out.
is forced out.
Steering cylinder
The steering cylinder has two grease nipples, one on each
end. Lubricate with a grease gun until the grease is forced
out.
end. Lubricate with a grease gun until the grease is forced
out.
Joint bearing
Grease the waist section of joint bearing Lubricate with a
grease gun until the grease is forced out.
grease gun until the grease is forced out.
Link brace
•
2 grease nipples, one on each side. Lubricate with a
grease gun until the grease is forced out.
grease gun until the grease is forced out.
Checking the engine’s oil level.
Check the oil level in the engine when the Rider stands
horizontal with the engine switched off.
horizontal with the engine switched off.
Open the engine cover.
Loosen the dipstick, pull it up and wipe it off.
Now insert the dipstick again.
Pull the dipstick out again and read the oil level.
The oil level should be between the markings on the dipstick.
If the level is approaching the ADD mark, top up the oil to the
FULL mark on the dipstick.
If the level is approaching the ADD mark, top up the oil to the
FULL mark on the dipstick.
The oil filler is on the valve cap. Fill the oil slowly.
Tighten the dipstick correctly before starting the engine. Start
and run the engine at idling speed for approx. 30 seconds.
Turn off the motor. Wait 30 seconds and check the oil level. If
necessary fill so that the oil comes up to the FULL mark on
the dipstick.
and run the engine at idling speed for approx. 30 seconds.
Turn off the motor. Wait 30 seconds and check the oil level. If
necessary fill so that the oil comes up to the FULL mark on
the dipstick.