Husqvarna WB48S e 用户手册

10 – 

English

Take care not to damage the cables and wires when you fold 
up the handlebar.

The upper part of the handlebar is attached with a sturdy 
handle nut on the baffle plate. Don't forget the washer 
between the plate and the handle nut.

If necessary, the handle can be turned slightly sideways with 
the handle joint. The handle can be set to different positions 
to achieve the best driving position, e.g. when mowing next to 
hedges or house walls. 

The handle can also be adjusted vertically by turning the 
wheels by the attachment fitting on the chassis

The ignition lead should always be removed from the spark 
plug before repair, cleaning or maintenance work.

Position the cutter with the spark plug upwards when 
servicing the machine. 

Always empty the fuel tank before you place the lawn mower 
on its side.

•

Unscrew the bolt holding the cutter.

•

Remove the bolt, spring washer and cutter. 

•

Place the cutter with the friction washer against the cutter 
bracket.

•

Make sure the cutter centres correctly on the shaft. 

•

To avoid vibrations, place the mower cutter so that the 
cutter bracket marking can be seen on the sides of the 
cutter.

•

Fit the washer and tighten the bolt correctly. The bolt 
should be tightened with a torque of 45-60 Nm.

•

Disconnect the HT lead from the spark plug.

•

Position the cutter with the spark plug upwards when 
servicing the machine. 

•

Fit the leader pins into the holes on the cutting cover.

•

Fasten the mulching plugs from the top of the cutting 
cover.