Husqvarna ZTH5223 用户手册

English-

33

Before removing the tank on the right of the mower, the rear wheel and the bolts holding the oil cooler for 
the hydraulics must be removed.

1.

Close the fuel valve (13).

2.

Drain the tank that is to be removed. 
Keep the drained fuel in a closed 
container.

3.

Remove the hose clamp (5) from the fuel 
line (6). 

4.

To catch any spills, position a container 
below the outlet from the tank to the fuel 
line. To ensure no damage is caused, 
hold the hose barb (4) with pliers and pull 
the fuel line away. Even when the tank is 
empty, a small amount of fuel may leak 
out.

5.

The tank is fitted to the splashguard by a 
bolt and two studs. Remove the bolt (16) 
and three nuts (10) - all with washers (8) 
and springs (9) - located on the 
underside of the splashguard. 

6.

Remove the bolt (12) and tank spacer 
located on the inside of the splashguard.

7.

Lift the fuel tank (2) away.

The fitting procedure is the reverse of the removal procedure.

Working from the underside of the splashguard, tighten each washer (8) spring (9) washer (8) combination 
using the appropriate nut (10) or bolt (16). Tighten until the spring starts to compress and then a further 1.5 
turns.

8011-607