Husqvarna ZTH5223 用户手册

English-

49

Refer to the “ZTH electrical system” diagram.

1.

Free the control console and pull forwards.

2.

Disconnect the wires at the back of the switch (11).

3.

Push in the plastic catch on the switch’s short side and draw the switch out through the console panel.

4.

With the plastic catch and two contact pins facing upwards, push the new switch into the console panel 
unitl it is correctly seated.

5.

Reconnect the wires at the back of the switch.

6.

Refit the control console.

See the “Troubleshooting” section towards 
the back of this manual.

See the “Troubleshooting” section towards 
the back of this manual.

See the “Troubleshooting” section towards 
the back of this manual.

1.

Drop the deck to its lowest position.

2.

Remove the operator’s foot plate.

3.

Using a 9/16" socket on the bolt of the 
idler pulley, loosen the deck belt. Roll the 
belt off the deck pulleys.

4.

Roll the belt off the clutch pulley on the 
crankshaft.

5.

Disconnect the cable feeding the clutch. 
The connector is located next to the left 
engine mount.

6.

Remove the bolt (9) and the lock washer 
(8).

7.

Remove the clutch (7) and the spacer 
(6).

8011-592

8011-6022