Husqvarna ZTH5223 用户手册

English-

50

The fitting procerdure is the reverse of the removal procedure.

Pay particular attention to the following:

•

The tightening torque for the bolt (9) is 67 Nm (50 ft/lb).

•

With the bolt (9) tightened, there should be perceptible play between the clutch and the clutch tie down 
(10) when the clutch flange is turned by hand. If necessary, adjust/twist the tie down.

•

Ensure that the cable cannot be damaged and secure it with a cable tie.

These micro switches are difficult to access. By pulling the control console forwards, it is possible to change 
the right switch without any other major dismantling. However, this does require two people. When 
changing the left switch, the tubular shafts (31, 33) of the motion control levers must be lowered or 
removed. The procedure for doing this is detailed below and may also be used for the right switch.

8011-589