Dekko 36H 用户手册

Rev: 8/2008 

 

16 of 21 

36B, 36BX, 36H, 36HX, 52H, 52HX 

DEK

® 

is exclusively distributed by GXi International, LLC 

To assure proper lubrication on moving parts, it is recommended that you lubricate the following components with a high-quality EP2 high 
temperature based grease or equivalent.  Should the conditions of operation be more severe than normal, the lubrication interval may be 
shorter than recommended.  GTR/OPE grease is the recommended lubricant.   

Lubrication point locations 
 
36” belt drive mowers have 13 lubrication points 
36” hydraulic drive mowers have 8 lubrication points 
52” mowers have 10 lubrication points 
 
 
 
Lubricate after every 50 hours of usage 

1.  Front wheel shafts (2 locations, one on each wheel 

shaft) 

2.  Spindles (2 locations for 36” and 3 locations on 52” 

mower decks).  Note:  the lower spindle bearing is 
sealed on the bottom and open on the top.  The up-
per spindle bearing is sealed on both sides.  Failure 
to frequently replenish grease will cause premature 
lower bearing failure.  Frequent application of 
grease to this bearing is critical to achieving long 
spindle life in harsh duty environments. 

3.  Mower deck idler pulley brackets (1 location for 36” and 

2 locations on 52”) 

4.  Blade activation rod supports (2 locations: one at the 

support under the fuel tank bracket and one adjacent to 
the engine.) 

5.  Hydraulic drive system idler puller support (1 location on 

hydro drive models only) 

6.  Belt drive system (6 locations:  2 locations on belt pulley 

supports on each side of the mower; 2 on the couplings 
between the transmission and the drive 
shafts.