Shindaiwa 62719-94310 用户手册

6

2.  Use the 4 mm hex wrench to loosen the 

tube clamp screw. See Figure5.

3.  Add some moly-type EP grease to 

splines at the end of the main shaft.

4.  Slide the outer tube into the tube clamp 

until the tube bottoms. If installation 

is difficult, rotate the outer tube or 

gearcase shaft slightly until you feel the 

mainshaft engage with the powerhead. 

See Figure 6.

1.  Place the powerhead on a clean, flat sur-

face, spark plug facing up. See Figure 5.

5.  Position the outer tube so that the igni-

tion switch is facing up and the throttle 

lever is facing down. See Figure 6.

6.  Slide the outer tube into the powerhead 

until the throttle grip just contacts the 

tube clamp.

Assembly

7. Tighten the clamp screw firmly.

CAUTION! 
Do not force the shaft tube into the 

powerhead! Excessive force can dam-

age the shaft tube and mainshaft.

23145

23106

1.  Remove the spark plug boot.
2.  Remove the two lower cylinder cover 

screws.

3.  Loosen the top cylinder cover screw  un-

til the cover is free of the engine. (The 

top cylinder cover screw is captive). 

Lift the cylinder cover off of the engine.                

See Figure 7.

3.  Connect the S-shaped end of the throttle 

cable to the throttle lever on top of the 

carburetor. See Figure 9.

1.  Loop the ribbed cable tube to the top 

left side of the engine. 

2.  Install the black wire between the 

two cable adjuster nuts as shown. See 

Figure 8.

23146

Assembly