Husqvarna 966067001 用户手册

oPERATIoN

19

Cut the grass to approximately ½" (1-1.5 cm) lower 

• 

than you normally would.
Do not water before sowing.

• 

Remove the layer of old grass cuttings (thatch).

• 

Aerate the lawn with a core-type ground aerator.

• 

Fertilize the lawn.

• 

Seed Application Chart
Located on the seeder, the chart values are 
approximate; quantities of seed depend on the speed 
at which the machine is run. Faster running speeds 
results in sparser sowing.
To set the seed application, loosen the wingnut and 
turn the seeder dial to the desired sowing setting. 
Retighten wingnut.
Pull back on the oPEN/CLoSE lever to apply seed.

For best results, sow in two directions with a 45° 

• 

angle between.
Water generously immediately afterward and 

• 

continue watering moderately for 10–14 days to 
keep the soil moist.
After germination, water sporadically to 

• 

encourage root growth.

To attach bagger, place foot on safety door rear bolt 
and push down until door is flat. Set the bagger onto 
the door and up against the chute.

Secure bag clamp.
To remove door, unlatch bag clamp. Push down on 
rear bolt and slide bagger away from the chute. The 
safety door is spring loaded and will flip up to cover 
the rear opening until the bag is reinstalled.

Selection dial

1. 

Wingnut

2. 

oPEN/CLoSE lever

3. 
Set application per chart and turn on seeder

Safety door

1. 

Rear bolt

2. 
Attach bag to bagger frame