Multiquip ga6HB 用户手册

This section is intended to assist the operator with the initial 

start-up of the portable generator. It is extremely important 

that this section be read carefully before attempting to use 

the generator in the field.

1.  Be sure to disconnect all electrical loads from the 

generator prior to starting the engine.

2. 

NEvER start the engine with the main circuit breaker 

in the 

ON position. Always place circuit breaker (Figure 12) 

in the 

OFF position before starting.

1.  Place the engine fuel valve lever (Figure 13) in the 

position.

2.  Place the choke lever (Figure 14) in the 

ClOsEd  

position if starting a cold engine.

Both model generators are equipped with a GFCI 

sensing module. The purpose of this module is to 

sense a ground fault during operation of the generator 

and shut down the generator once the ground fault has 

been detected.
Multiquip recommends that the GFCI sensing module 

be tested before each use of the generator. Reference 

the maintenance section of this manual for the testing 

of the GFCI sensing module.

ON

OFF

3.  Place the choke lever (Figure 14) in the 

OpeN position 

if starting a warm engine or the temperature is warm.

4.  Place the generator's operation switch (Figure 15) in 

the 

ON position.

5.  If your generator is a recoil start only (no battery), grasp 

the starter grip (Figure 16) and slowly pull it out. The 

resistance becomes the hardest at a certain position, 

corresponding to the compression point. Pull the starter 

grip briskly and smoothly for starting.
Proceed to step 6 if your unit is an electric start model 

(battery installed).

ON

OFF

GA-6HB

GA-6HEB

ON

dO NOT pull the starter rope all the way to the end.
dO NOT release the starter rope after pulling. Allow it 

to rewind as soon as possible..