Revolutionary Cooling Systems PVP1800 用户手册

 

 

 

 

breaker panel is switched off before you connect the AC terminal block.   

 

To wire the StarInverter to the main utility grid, follow the steps outlined below (refer to 

Figure 8): 
            

1.  Run the conduit from the main breaker panel to the bottom of the StarInverter 

and insert the fitting in the center opening of the StarInverter, fastening with a 

locking nut.   

 

2.  Feed the LINE, LINE 2/NEUTRAL and GROUND wires through the conduit and 

into the center opening of the StarInverter.   

 

3.  Connect the GROUND wire to the terminal marked ‘earth ground’ inside the 

StarInverter.   

 
4.  Connect the LINE 2/NEUTRAL wire to the terminal marked ‘line 2/neutral’ inside 

the StarInverter.    

 

5.  Connect the LINE wire to the terminal marked ‘line’ inside the StarInverter.   
 
6.  Ensure all connections are wired correctly and properly torqued.  Tighten the 

terminal block screws to 0.5 Nm. 

 

 

 

 

 
                        

PV Powered LLC 

10 

18-28-405