Roland PCR-800 用户手册

RPN/NRPN advanced editing 1 lets you specify the upper limit and lower limit for 
the data entry MSB (CC#6) of the transmitted RPN/NRPN message, in addition to 
allowing you to make the settings described in basic editing.

Press the [EDIT] button so it’s lit.

Slightly move the controller to which you want to assign an RPN or NRPN 
message. If the controller is a button, press it. The display will indicate the 
number of the controller you selected.

Check the indication in the display, then press the [ENTER] button.

Turn the VALUE knob to make “RP” appear.
* If you want to assign an NRPN, make “NP” appear. The rest of the procedure is the 

Press the [ENTER] button.

Turn the VALUE knob or press controller [A2 (1)] to select the “RP1” 
indication.

Press the [ENTER] button.

Enter the channel.

Press the [ENTER] button.

Use the VALUE knob or controllers [A1]–[A8] and [B1]–[B8] to specify the 
RPN MSB (CC#101) (or the NRPN MSB (CC#99)).

Press the [ENTER] button.

Use the VALUE knob or controllers [A1]–[A8] and [B1]–[B8] to specify the 
RPN LSB (CC#100) (or the NRPN LSB (CC#98)).

Press the [ENTER] button.

Specify the range of the data entry MSB (CC#6).
(-> Specifying the value range (upper/lower limits) (p. 45))

Specify the output port.
(-> Port setting (p. 65))

As appropriate for the type of controller, set the button mode (p. 64) or 
make virtual center click settings (p. 65).

PCR-300_500_800_e.book 54 ページ ２００６年１２月１９日　火曜日　午後２時５９分