Roland XV-3080 用户手册

The XV-3080 has three sets of stereo outputs.

These outputs allow you to separate sounds – or groups of sounds – from the XV-3080’s overall stereo mix, and to send them to 
their own external destinations. For example, you could route a stereo Rhythm Set to a pair of output jacks connected to an 
external effects device. You can also use the three pairs of jacks as six independent output jacks to which you can route Tones, 
Rhythm Tones or Patches.

This chapter describes the signal paths in the XV-3080’s various modes, along with the associated parameters. Please refer to this 
section when selecting your outputs.

fig.3-01

The parameters related to Patch output settings are shown 
below.

This sets the output destination and level for the currently 
selected Tone as well as its send level to the Chorus and 
Reverb.

 The Tone is sent to the Multi-Effects. The Tone’s final 

output destination is determined by the Multi-Effects output 
setting.

 The Tone is routed to the OUTPUT A–C 

jacks.

 The Tone is routed to the INDIVIDUAL 1–6 jacks.

This sets the Tone’s send level to the Chorus. Its final output 
destination is determined by the Chorus output setting.

This sets the Tone’s send level to the Reverb. Its final output 
destination is determined by the Reverb output setting.

This sets the volume of the Patch.