Roland R-1 用户手册
70
Troubleshooting
Power won’t turn on
Make sure that the AC adaptor is connected correctly.
If you’re using batteries, check the polarity of the batteries, and make sure that each
battery is firmly seated in the holder. It is also possible that the batteries have run down;
try a fresh set of batteries.
If you’re using batteries, check the polarity of the batteries, and make sure that each
battery is firmly seated in the holder. It is also possible that the batteries have run down;
try a fresh set of batteries.
Refer to:
If the R-1 will not turn on even though there is no problem with the AC adaptor or
batteries, it is possible that the R-1 has malfunctioned.
Please contact “Service Information” listed at the end of this manual.
batteries, it is possible that the R-1 has malfunctioned.
Please contact “Service Information” listed at the end of this manual.
My computer doesn’t detect the R-1 when I connect it
Your computer will not correctly detect the R-1 if no CompactFlash memory card is
inserted. If the R-1 does not appear on your computer desktop, check that a
CompactFlash memory card is correctly inserted.
inserted. If the R-1 does not appear on your computer desktop, check that a
CompactFlash memory card is correctly inserted.
Refer to:
Pressing the MENU button doesn’t take me to Setup mode
You can’t enter Setup mode during playback or recording. Stop playback or recording,
and then press the
and then press the
MENU button
to enter Setup mode.
If the R-1 is playing, recording, or in recording-standby mode, pressing the
MENU
button
won’t put you in Setup mode.
Refer to:
Backlight turns off
If you’re using the R-1 on batteries, the backlight may turn off when the R-1 has not been
operated for a certain length of time, depending on the LCD Backlight setting.
operated for a certain length of time, depending on the LCD Backlight setting.
Refer to:
The R-1 goes to sleep
If you’re using the R-1 on batteries, it may go to sleep if no operation has been
performed for a certain length of time, depending on the Sleep Timer setting. You can
use Setup mode 11 Sleep Timer to change this setting.
performed for a certain length of time, depending on the Sleep Timer setting. You can
use Setup mode 11 Sleep Timer to change this setting.
Refer to:
The settings I made have disappeared
If all of the effects and Setup mode settings you made have returned to their original
state, it is possible that you inadvertently restored the R-1 to its factory-set state.
state, it is possible that you inadvertently restored the R-1 to its factory-set state.
Refer to:
Other problems
R-1_egfis1.book 70 ページ ２００５年１１月１１日 金曜日 午後５時１３分