Roland SP-606 用户手册
18
Top, Front, and Rear Panels
7
INT/EXT buttons
These buttons switch between Internal and External
modes. Normally you will leave Internal mode selected.
(p. 15)
modes. Normally you will leave Internal mode selected.
(p. 15)
FUNC button
You can hold down [FUNC] and press another button or
pad to access an alternate function for that button or pad.
pad to access an alternate function for that button or pad.
CLIP BOARD button
This button lets you use the clip board to copy a sample.
(p. 32)
(p. 32)
SAMPLING button
PAD BANK button
ROLL button
HOLD pad
INPUT SOURCE pad
Pads [1]–[16]
fig.front-panel
Memory card slot
* You can use a Phillips screwdriver to remove the two screws
immediately under each end of the card slot (i.e., on the SP-
606’s bottom panel edge closest to yourself), and use these same
two screws to attach the included card theft prevention cover.
This will prevent the memory card from being removed and
stolen.
606’s bottom panel edge closest to yourself), and use these same
two screws to attach the included card theft prevention cover.
This will prevent the memory card from being removed and
stolen.
* When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons and
controls. Also, you should try to orient the unit so no buttons
or controls get damaged.
corners or at both ends to prevent damage to the buttons and
controls. Also, you should try to orient the unit so no buttons
or controls get damaged.
* When turning the unit upside-down, handle with care to avoid
dropping it, or allowing it to fall or tip over.
Front Panel
SP-606_e.book 18 ページ 2004年6月21日 月曜日 午前10時8分