Roland SP-606 用户手册

 

fig.rear-panel

 

 

Depending on the circumstances of a particular setup, 
you may experience a discomforting sensation, or 
perceive that the surface feels gritty to the touch when 
you touch this device, microphones connected to it, or the 
metal portions of other objects. This is due to an 
infinitesimal electrical charge, which is absolutely 
harmless. However, if you are concerned about this, 
connect the ground terminal (see figure) with an external 
ground. When the unit is grounded, a slight hum may 
occur, depending on the particulars of your installation. 
If you are unsure of the connection method, contact the 
nearest Roland Service Center, or an authorized Roland 
distributor, as listed on the “Information” page.

Unsuitable places for connection

• Water pipes (may result in shock or electrocution)

• Gas pipes (may result in fire or explosion)

• Telephone-line ground or lightning rod (may be 

dangerous in the event of lightning)

 

 

 

Use a USB cable to connect the SP-606 to your computer. 
(p. 83)

 

 

Connect your audio source to the IN jack if you want to 
sample via the digital input. Connect to the OUT jack if 
you want to use digital output. (p. 20)

 

You can connect a foot switch (DP-2, BOSS FS-5U; sold 
separately) to this jack. (p. 20)

 

Connect your audio source or microphone to this jack if 
you want to sample via the analog input. If you’re 
inputting a monaural source, connect it to the L (MONO) 
jack. (p. 20)

 

These are analog output jacks. If you’re outputting in 
monaural, use the L (MONO) jack. (p. 20)

 

Connect a set of stereo headphones to this jack. Even if 
headphones are connected, sound will still be output 
from the DIGITAL OUT and OUTPUT jacks. (p. 20)

 

http://www.kensington.com/

SP-606_e.book 19 ページ ２００４年６月２１日　月曜日　午前１０時８分