Roland VS-1824 用户手册
243
Chapter 19 Using a DAT Recorder (DAT Backup)
Chapter 19
2. Insert the tape that contains the song data into the DAT
recorder. If the song data is backed up on two or more
tapes, insert the first tape.
tapes, insert the first tape.
3. Rewind the tape to begin playback from the beginning of
song data.
4. Hold [SHIFT] and press [F6 (UTILITY)].
The Utility Menu icon appears in the display.
5. Press [PAGE] so “DATRc” appears in the display above
[F1]. Press [F1 (DATRc)].
6. Press [
] to move the cursor to “Digital In Select” and
turn the TIME/VALUE dial.
Digital In Select
Select either “DIGIN1” (coaxial) or “DIGIN2” (optical).
7. Press [F1 (Name)].
“Please Play DAT” appears in the display.
8. Put the DAT recorder in play. The song name will load.
9. When the procedure is finished, “Please Stop DAT”
appears in the display. Stop the DAT recorder and press
[ENTER/YES]. The DAT Name screen appears in the
display.
[ENTER/YES]. The DAT Name screen appears in the
display.
fig.09-06a
10. If you wish to end the operation after checking the song
names, press [PLAY (DISPLAY)] to return to the Playlist
display.
display.
If you wish to recover the song data, please refer to
“Recovering Data from a DAT,” p. 241.
“Recovering Data from a DAT,” p. 241.
DAT Backup Verification
This operation checks the condition of song data that was
recorded to a DAT tape. It does not perform a comparison of
the song data on the hard drive and the song data on the
tape. If the DAT verify operation results in a warning that
data is not recorded properly, it is possible the tape has been
scratched or stretched. If the original song data still exists on
the drive, perform the DAT backup procedure once again
using a different DAT tape.
recorded to a DAT tape. It does not perform a comparison of
the song data on the hard drive and the song data on the
tape. If the DAT verify operation results in a warning that
data is not recorded properly, it is possible the tape has been
scratched or stretched. If the original song data still exists on
the drive, perform the DAT backup procedure once again
using a different DAT tape.
* After performing DAT backups, in order to confirm the data
has indeed been properly backed up, we strongly recommend
you carry out the Verify procedure.
you carry out the Verify procedure.
1. Connect the VS-1824 and the DAT recorder as shown
below.
fig.09-06c
fig.09-06d
DAT recorder
Digital Out
Optical
DAT recorder
Digital Out
Coaxial