Roland VS-1824 用户手册

The VS-1824 has eight analog output jacks and two stereo 
digital outputs. Each of these outputs can have various 
signals assigned to them. Use the following procedure to 
determine the signal for each output jack or connector.

1. Press [EDIT/SOLO]. The Master Block is displayed.

2. Use [

], [

], [

], and [

] to move the 

cursor to “OUTPUT (MON).” Use the TIME/VALUE 
dial to adjust the setting.

fig.11-44a

This selects what signal is to be assigned to the MONITOR 
jacks.

The signal at the MASTER jacks (MIX bus).

The signal at the EFFECT 1 bus.

The signal at the EFFECT 2 bus.

The signal at the AUX1 bus, or EFFECT 3—the EFFECT 3 
bus—when a second VS8F-2 effect card is installed in the 
VS-1824.

The signal at the AUX2 bus, or EFFECT 4—the EFFECT 4 
bus—when a second VS8F-2 effect card is installed in the 
VS-1824.

The signal at the AUX3 bus, or AUX—the AUX bus—
when a second VS8F-2 Effect card is installed in the
VS-1824.

The signal at the RECORDING bus.

The signal assigned to the STEREO IN.

3. Press [F2(Mon)]. If “Mon” does not appear above [F2], 

press [PAGE] until “Mon” appears above [F2], and then 
press [F2(Mon)].

fig.11-44

This adjusts the volume level (0-127) for the MONITOR 
jack. This is normally adjusted using the MONITOR 
knob on the top panel.

This adjusts the left-right balance (L63-R63) for the 
MONITOR jacks.

4. Press [PLAY (DISPLAY)] to return to the Playlist display.

Level

Balance