Roland VS-1824 用户手册

Chapter 5 Using the Digital Mixer

Chapter 5

AUX Connectors

1. Press [EDIT/SOLO]. The Master Block is displayed.

2. Press [F3 (AUX.A)].

If “AUX.A” does not appear above [F3], press [PAGE]
until “AUX.A” appears above [F3], and then press
[F3 (AUX.A)].

3. Determine what signal is assigned to the AUX jacks by

turning the TIME/VALUE dial.

fig.11-45

AUX A

This selects which signal is assigned to the AUX A jacks.

FX1:

The signal at the EFFECT 1 bus.

FX2:

The signal at the EFFECT 2 bus.

AUX1/FX3:

The signal at the AUX1 bus, or EFFECT 3 when a second
VS8F-2 effect card is installed in the VS-1824.

AUX2/FX4:

The signal at the AUX2 bus, or EFFECT 4 when a second
VS8F-2 effect card is installed in the VS-1824.

AUX3/AUX:

The signal at the AUX3 bus, or AUX when a second
VS8F-2 effect card is installed in the VS-1824.

4. Press [PLAY (DISPLAY)] to return to the Playlist display.

The AUX B jacks are set using the same method. Press [F4
(AUX.B)] at Step 2.

Digital Out Connectors

1. Press [EDIT/SOLO]. The Master Block is displayed.

2. Press [F5 (DOUT1)].

If “DOUT1” does not appear above [F5], press [PAGE]
until “DOUT1” appears above [F5], and then press [F5
(DOUT1)].

3. Determine what signal is assigned to the DIGITAL OUT

1 connector by turning the TIME/VALUE dial.

fig.11-46

DOUT1 (DIGITAL OUT 1)

This selects what signal is assigned to the DIGITAL OUT
1 (coaxial) connector.

MST:

The signal at the MASTER jacks (MIX bus).

MON:

The signal at the MONITOR jacks.