Roland SPD-S 用户手册

下载
页码 144
 
74
 
Chapter 7 Changing the Setup (Overall 
Environment)
 
This chapter describes steps for making environment settings in Setup Edit.
 
Basic Operations for Setup Edit
 
1
 
Set the SPD-S to the patch or wave mode.
 
2
 
Press [SETUP] to access Setup Edit.
 
3
 
Press the PAGE buttons to select an item to be edited from those listed 
below, and then press [ENTER].
 
To select another item after pressing [ENTER], press [EXIT].
For details on each item, see its reference page.
 
SYSTEM
 
 
PAD
 
 
CONTROL SW
 
 
TRIGGER INPUT
 
 
MIDI
 
• BULK DUMP
• INIT/DELETE (Initialize/Delete)
 
4
 
Press the PAGE buttons to change the parameter for the item.
 
To change settings for individual pads/triggers or foot switch, hit a pad for 
which the settings are to be changed to select it. A flashing pad indicator 
shows which pad/trigger is selected.
 
5
 
Press [-]/[+] to change the value of the parameter.
 
6
 
Press [EXIT] and then repeat Steps 3 to 5 to continue Setup Edit 
operations. Press [PATCH] or [WAVE] to finish Setup Edit.
 
The SPD-S saves the settings (with “now writing..” indicated) and then 
returns to the patch or wave mode.
If you press [PATCH], the 
SPD-S goes into the patch 
mode. If you press [WAVE], it 
goes into wave mode.
When there are more choices, 
PAGE buttons ([<], [>], or 
both) are lit.
When it is necessary to press 
[ENTER], it is flashing.
Or, you can hold down 
[SHIFT] and press the PAGE 
buttons to choose a pad/
trigger.
If you hold down [SHIFT] and 
press [FUNC], the parameter is 
reset to its initial value.
SPDS_e.book 74 ページ 2004年4月19日 月曜日 午前9時58分