Roland RD-700SX 用户手册

 

This chooses the piano Tone to be selected when ONE TOUCH 
[E.PIANO] is pressed.

There are 21 Tones to choose from.

In the past, the sounds of electric pianos and similar instruments 
were always played through some kind of instrument amp.

The function simulates the sonic characteristics of these instrument 
amps.

You can use effects that are often used with electric pianos.

This sets the midrange equalization.

 

Depending on the piano Tone selected, this setting may not be 
available.

You can make changes in tones by adjusting the settings of the 
elements.

 

The time it is to take following the attack for the volume to decrease.

 

Adjusts how much the filter is opened.

 

Emphasizes the overtones in the region of the cutoff frequency, 
adding character to the sound. Excessively high settings can produce 
oscillation, causing the sound to distort

 

The time it takes after the key is released for a sound to become 
inaudible.

 

Making abrupt changes in the settings values may cause the 
sound to become distorted or overly loud. Carefully monitor 
volume levels while making the settings.

 

AMP Type

OFF

No amp is used.

EP-AMP

This simulates the amp section of a 
vintage electric piano featuring a 
built-in amp.

GTR-AMP

This simulates a multipurpose guitar 
amp.

 

Effect Type

OFF, CHORUS, 
TRERMOLO, 
AUTO-WAH, 
PHASER

Selecting the type of effects.

Effect Depth

0–127

This sets the amount of effect 
applied to the sound. 
Increasing the value deepens 
the effect, while the effect gets 
weaker at lower values.

Effect Rate

1–200

This sets the rate of the effect's 
cycling. Increasing the value 
deepens the effect, while the 
effect gets weaker at lower 
values.

 

EQ SW

ON, OFF

This determines whether the 
following EQ-Freq, EQ Gain, 
and EQ Q settings are 
enabled (ON), or not (OFF).

EQ Gain

-12.0–+12.0 dB

Change the amount of 
equalization (gain).

EQ 
Frequency

100, 125, 160, 200, 
250, 315, 400, 500, 
630, 800, 1000, 
1250, 1600, 2000, 
2500, 3150, 4000Hz

Set Frequency Point. Changes 
the level of the selected 
frequency range, with 
frequency selected here at the 
center.

EQ Q

0.5, 1.0, 2.0, 4.0, 8.0

Adjusts the “Q” (bandwidth) 
of equalization. The higher 
the value, the narrower the 
range of frequencies that are 
affected.

 

Decay Time 
(Offset)

-64–+63

The time it takes for the volume to fall 
increases as the value is raised; 
lowering the value decreases the 
decay time. 

Cutoff 
(Offset)

-64–+63

Higher values brighten the sound; 
lower values make the sound seem 
darker.

Resonance 
(Offset)

-64–+63

Higher value makes the special quality 
of the sound stronger; lower value 
reduce these characteristics.

Release Time 
(Offset)

-64–+63

Higher values produce longer decay; 
set lower values for a clear-cut sound

RD-700SX_e.book 77 ページ ２００６年３月２３日　木曜日　午後２時５２分