Roland XV-88 用户手册

The XV-88 allows you to preview Patches by hearing a 
phrase appropriate for each type of Patch.

1. Select a Patch (p. 29).

2. Press and hold [PHRASE PREVIEW].

• In Performance mode, only the Patches of the currently 

selected Part (current Part) will sound. In Rhythm Set 
mode, a drum phrase will sound.

• Patches of the USER group or from an optional Wave 

Expansion Board (SR-JV80 Series and SRX Series) may 
not sound at the appropriate pitch range. If this occurs, 
press [+OCT] or [-OCT] to select the desired pitch range 
(Octave Shift p. 47).

• If the pitch range of a Phrase is wider than the range of 

the Tones within a Patch (p. 73), or wider than the range 
of a Part within a Performance (p. 51), any notes in the 
Phrase that fall outside that range will not be heard.

3. Release your finger from [PHRASE PREVIEW], and the 

phrase will stop playing.

4. To change the way in which the phrase is played, press 

[SYSTEM] to make the indicator light. Then press the 
[PREVIEW] function button, and press

or

to 

access the SYSTEM PREVIEW page.

fig.09-21

5. Rotate the VALUE dial, or press [INC/+]/[DEC/-] to 

make the setting.

: The notes specified by Note 1–4 parameter 

(SYSTEM/PREVIEW/PREVIEW KEY) will sound 
successively one by one.

: The notes specified by Note 1–4 parameter 

(SYSTEM/PREVIEW/PREVIEW KEY) will sound 
simultaneously.

: The Phrase associated with the Patch’s type/

category is played.

For details on the Note 1–4 parameter settings, refer to 

6. Press [EXIT] to return to the PATCH PLAY page.

7. If you set the Preview Mode parameter to PHRASE in 

step 5, you can specify the phrase that will sound. After 
pressing [EDIT] to make the indicator light up, press the 
[COMMON] function button, and press

or

to 

display the PATCH CATEGORY page.

fig.05-08

8. Rotate the VALUE dial or press [INC/+]/[DEC/-] to 

make the setting. For details on the available categories, 
refer to (p. 31).

The Patch Finder function uses this setting.

Since a Patch is a combination of up to four Tones, you can 
switch unwanted (Tones out of the four) off and get just the 
sound of a specific Tone.

1. Make sure that the PATCH PLAY page is displayed.

2. Make sure that [EDIT] indicator is extinguished. If it is 

lit, press [EDIT].

At this time, the on/off setting of each Tone in the 
displayed Patch will be shown by the indicators of 
TONE SWITCH [1]–[4]. Lit is on, and dark is off.

The PATCH PLAY page indicates the Tones that are on 
as follows. Tones that are off are shown as 

.

fig.02-06

3. Use TONE SWITCH [1]–[4] to switch Tones on/off.

This setting is linked with the Switch parameter 
(PATCH/WAVE/WAVE). If you want just one or two 
Tones to sound in a Patch, turn the others off and store 
that setting on a Patch. This cuts nonessential use of the 
XV-88’s simultaneous voices.