Roland XP-30 用户手册

Before installing the Wave Expansion Board, turn off the 
power of the XP-30 and all connected devices, and disconnect 
all cables from the XP-30.

Turn the XP-30 on its back, and remove only the screws shown 
in the following diagram.

fig.Q-02a.e

Inside, there are two connectors and six board holders. Insert 
the connectors of the Wave Expansion Board into the internal 
connectors, and simultaneously insert the board holders into 
the holes of the Wave Expansion Board.

fig.Q-02b.e

If the same type of Wave 
Expansion Board is 
installed in the EXP-D slot 
and the EXP-E slot, it will 
only be possible to select 
data from the Wave 
Expansion Board that was 
installed in the EXP-D slot. 
Also, the XP-30 already 
contains the data of the 
following three Wave 
Expansion Boards, so if one 
of these Wave Expansion 
Boards is installed, only the 
internal data (XP-A–C) can 
be selected.

SR-JV80-09 “Session” 
(XP-A)

SR-JV80-02 “Orchestral” 
(XP-B)

SR-JV80-11 “Techno 
Collection” (XP-C)

Screws to be removed

Wave Expansion Board

Connector

Board holder