Roland XP-30 用户手册
16
Getting Ready
Installing the Wave Expansion Board
Up to two Wave Expansion Boards (SR-JV80 series; sold separately) can be
installed in EXP-D and E Slots in the XP-30. Wave Expansion Boards contain
Wave data, as well as Patches and Rhythm Sets that use this Wave data,
which can be called directly into the temporary area and played.
installed in EXP-D and E Slots in the XP-30. Wave Expansion Boards contain
Wave data, as well as Patches and Rhythm Sets that use this Wave data,
which can be called directly into the temporary area and played.
■
Cautions When Installing an Wave Expansion Board
● To avoid the risk of damage to internal components that can be caused by
static electricity, please carefully observe the following whenever you
handle the board.
• Before you touch the board, always first grasp a metal object (such as
handle the board.
• Before you touch the board, always first grasp a metal object (such as
a water pipe), so you are sure that any static electricity you might
have been carrying has been discharged.
have been carrying has been discharged.
• When handling the board, grasp it only by its edges. Avoid touching
any of the electronic components or connectors.
• Save the bag in which the board was originally shipped, and put the
board back into it whenever you need to store or transport it.
● Use a Philips screwdriver that is suitable for the size of the screw (a
number 2 screwdriver). If an unsuitable screwdriver is used, the head of
the screw may be stripped.
the screw may be stripped.
● To remove a screw, rotate the screwdriver
counter-clockwise. To tighten a screw, rotate
the screwdriver clockwise.
the screwdriver clockwise.
● When installing Wave Expansion Boards,
remove only the specified screws.
● Be careful that the screws you remove do not drop into the interior of the
XP-30.
● Do not leave the bottom cover in a detached state. Be sure to reattach it
after the Wave Expansion Boards have been installed.
● Do not touch any of the printed circuit pathways or connection terminals.
● Be careful not to cut your hand on the edge of the installation bay.
● Never use excessive force when installing a circuit board. If it doesn’t fit
● Be careful not to cut your hand on the edge of the installation bay.
● Never use excessive force when installing a circuit board. If it doesn’t fit
properly on the first attempt, remove the board and try again.
● When circuit board installation is complete, double-check your work.
To install an optional Wave Expansion Board (SR-JV80 series; sold
separately), the unit’s bottom cover must be removed. There are two slots
(EXP-D and E) into which a board can be installed. Slots EXP-D and E
correspond to the group (XP-D and E) you need to select in order to use a
Wave, Patch or Rhythm Set from the Wave Expansion Board.
separately), the unit’s bottom cover must be removed. There are two slots
(EXP-D and E) into which a board can be installed. Slots EXP-D and E
correspond to the group (XP-D and E) you need to select in order to use a
Wave, Patch or Rhythm Set from the Wave Expansion Board.
When playing a Patch or
Rhythm Set that use the
Wave data from a Wave
Expansion Board, the
appropriate Wave
Expansion Board must be
installed in the XP-30 for
the sound to play correctly.
Rhythm Set that use the
Wave data from a Wave
Expansion Board, the
appropriate Wave
Expansion Board must be
installed in the XP-30 for
the sound to play correctly.
tighten
loosen