Roland FC-300 用户手册

 

You can transmit Control Change messages through operation of the expression 
pedals, control pedals, and other controllers.

In keeping with the movement of the expression pedal, Control Change messages 
with the controller numbers set for each pedal are transmitted consecutively.

Each pedal is set at the factory as shown below.

All Assign Numbers from 2 on are set to OFF. For more information about the Assign 
Numbers, see 

 

You can connect separately available footswitches and expression pedals and use the 
external pedals just like the FC-300’s pedals to transmit MIDI messages.

Each pedal is set at the factory as shown below.

All Assign Numbers from 2 on are set to OFF. For more information about the Assign 
Numbers, see 

 

 

EXP PEDAL 1 (Assign Number=1)

7

0–127

EXP PEDAL 2 (Assign Number=1)

1

0–127

 

CTL PEDAL 1

80

0–127

LATCH

CTL PEDAL 2

81

0–127

LATCH

EXP PEDAL SW 1 (Assign Number=1)

82

0–127

LATCH

EXP PEDAL SW 2 (Assign Number=1)

83

0–127

LATCH

For details about the all 
parameters and changes the 
setting, refer to “Change the 
Pedal Settings”

You can use the control pedal 
and expression pedal switch to 
switch the AMP CONTROL 
jacks – see “Change the Pedal 
Settings”

The Control pedal and EXP 
pedal are the latch type pedal 
that sends an ON or OFF 
message each time you depress 
it. You can change this to 
momentary type operation, 
which sends an ON message 
when depressed and an OFF 
message when released – see 
“Mode”

FC-300_e1.book 30 ページ ２００７年４月２４日　火曜日　午前１０時１０分