Roland SP-555 用户手册

 

This indicator helps you adjust the MIC or LINE IN level. 
Adjust the level so that this indicator lights occasionally.

 

This adjusts the volume of the LINE OUT and PHONES 
output.

 

When you press this button so it’s lit, the metronome will 
sound at the BPM of the pattern sequencer. To adjust the 
volume of the metronome, hold down this button and turn 
the CTRL 3 knob.

 

You can’t sound the metronome while sampling.

 

This will blink according to the audio signal level while 
sampling, or in sync with the pattern tempo while using the 
pattern sequencer.

 

➜

 

 

 

This shows the BPM (tempo) of the sample or pattern, the 
values of various settings, and error messages. You can 
also view the remaining sampling time here (

 

➜

 

 

By pressing this button several times at the desired tempo, 
you can set the tempo to the corresponding interval.

 

You can apply a variety of effects to the sound by moving 
your hand over this (

 

➜

 

blink when the D Beam controller responds.

 

Use the D Beam controller to play internal synthesizer 
sounds.

 

Use the D Beam controller to control the cutoff frequency 
of the internal filter.

 

Use the D Beam controller to trigger the desired pad.
If you hold down the TRIGGER button and press a pad, the 
D Beam controller will trigger that pad.

 

➜

 

Press this when you want to play or record a pattern. 
While this button is lit, you can select a pattern by pressing 
a pad.

 

When recording a pattern, this specifies the length of the 
pattern.

 

This specifies automatic timing adjustments (quantization) 
when recording a pattern.

 

These control the parameters that are assigned to each 
knob by the selected effect. You will also use these knobs 
for the following purposes.

 

➜

 

 

 

➜

 

 

 

Use this to adjust the starting location of a sample, or to 
change the playback time of a sample.

 

Use this to adjust the BPM (tempo) of the pattern, or to 
change the ending location of a sample.

 

Use this to select the type of MFX, or to adjust the sampling 
level or the volume of the sample.

 

Use these to select the effect you want to use. A button is 
lit when on, and extinguished when off.

 

* You can’t turn on more than one effect at the same time.
* By holding down the 

 

 and pressing 

one or more pads, you can turn on the effect for one or more 
pads.

 

Here you can record the currently playing sample or 
pattern, or a phrase from an external input source (up to 
approximately 15 seconds).

 

➜

 

 

 

This specifies the number of measures to be recorded. If 
you specify FREE, you’ll be able to record up to 
approximately 15 seconds.

 

If you turn this button on, recording will begin 
automatically when sound is input.

 

This selects what will be recorded. 

 

 will record 

only the signal from the mic, line input, or built-in 
sequencer controlled by the D Beam. 

 

 will 

record this sound mixed with the currently playing 
sample/pattern.

 

Pressed to start recording. During recording, press this 
button to stop recording. You can also use this to layer an 
additional sample during LOOP CAPTURE playback.

SP-555_e.book 11 ページ ２００７年６月２５日　月曜日　午前９時９分