Roland VH-11 用户手册
5
Mounting on the Hi-Hat Stand
1.
Remove the clutch included with the hi-hat
stand from the cymbal rod.
* The clutch included with the hi-hat stand will not be used.
* It is not necessary to remove the felt (or rubber) pad on the hi-
hat stand used for supporting the bottom cymbal.
2.
Confirm that the cymbal rod is firmly secured.
For instructions on tightening the cymbal rod, refer to the
owner’s manual for your cymbal stand.
owner’s manual for your cymbal stand.
* Looseness or play in the cymbal rod can make the top hi-hat
unstable, causing it to shake or turn, and prevent proper
functioning.
functioning.
3.
Place the insulating plate on the hi-hat stand
with the cymbal rod passing through the hole of
the insulating plate.
Set the insulating plate with the sponge side facing up.
4.
Place the motion sensor unit on the insulating
plate with the cymbal rod passing through the
hole of the motion sensor unit.
Position the CONTROL OUT jack on the farther side, as
viewed from the player.
viewed from the player.
5.
Loosen the clutch screw and place the hi-hat on
the motion sensor unit with the cymbal rod
passing through the hi-hat hole.
Position the “Roland” logo on the farther side, as viewed
from the player.
from the player.
fig.Assy.e
Cymbal Rod
Insulating Plate
Sponge side up
Hi-Hat
“Roland” logo
on the farther side
on the farther side
Motion Sensor Unit
CONTROL OUT jack
on the farther side
on the farther side
Clutch Screw
VH-11_e 5 ページ ２００５年４月１２日 火曜日 午後１時２０分