Extron electronic VLM 1000 用户手册

下载
页码 30
1-6
Introduction 
— 
Inventory Overview, cont’d
VoiceLift Microphone Installation • Introduction — Inventory Overview
b.  Items not included
The following items are not included.  However, some or all of these items may be needed for the installation at your 
particular site.
•  Additional length of RJ-45 cabling (CAT 5, 5e, or 6 with T568A or T568B straight-through wiring)
•  Installation hardware (may vary by installation): 
  Electrical ceiling box, 3.5" or 4.0"  
  Junction box 
Plaster ring 
  Raceway 
  Bolts for concrete structural ceilings where needed  
  Dry wall anchors and screws 
  Spare ceiling tiles in case of accidental damage during installation 
  Safety wire, lag eye bolts, and strain reliefs 
  Heat shrink, extension cord
c.  Optional items
The optional items suggested below can be added to or substituted for items in the standard VoiceLift Microphone 
kit.
•  VLR 102 SR Secondary VoiceLift Receiver
•  VLC 102 Charging Station
•  VLP 102 pendant microphone (additional)
•  Wall charger
•  Headset microphone
•  Lapel microphone
•  Lanyard
•  Lanyard clip
•  IPL T S1 Ethernet Control Interface
d.  Installation tools:
•  Tape measure
•  Screwdriver set and Tweeker
•  Hole saw, keyhole saw, or razor knife
•  Appropriate drill and bit set for the mounting surface
•  Stud finder
•  Flashlight
•  Safety goggles
•  RJ-45 crimpers and connectors (plenum rated, if applicable)
•  Zip ties
•  Vacuum cleaner
N