Schumacher SC-7500A 用户手册

下载
页码 16
9
CHARGER CONTROLS
DISPLAY MODE SWITCH 
Use this switch button to set the function of 
the digital display to one of the following. 
  BATTERY %: The digital display shows 
an estimate of the percent of charge of 
the  battery  connected  to  the  charger 
battery clamps.
• 
VOLTAGE: The digital display shows the 
voltage at the charger battery clamps in 
DC volts.
•  ALTERNATOR  %:  The  digital  display 
shows an estimated percentage of the 
output  of  the  vehicle  charging  system 
connected to the charger battery clamps 
as compared to a properly functioning 
system.
BATTERY TYPE SWITCH 
Use this switch button to set the type of 
battery  to  be  charged  to  one  of  the  fol-
lowing.
• 
12V  REGULAR:  This  is  the  type  of 
battery  usually  used  in  cars,  trucks, 
and motorcycles. These batteries have 
vent  caps  and  are  often  marked  “low 
maintenance” or “maintenance-free”.
• 
12V DEEP CYCLE: Deep cycle batter-
ies are usually marked as “deep cycle” 
or  “marine”.  Deep  cycle  batteries  are 
usually larger than the other types.
• 
12V AGM/GEL: AGM and gel cell bat-
teries have sealed cases without vent 
caps. Such batteries are often smaller 
than the other types.
• 
6V REGULAR: This is the type of bat-
tery usually used in antique and some 
specialized vehicles. The 6V REGULAR 
battery type is not selectable for batteries 
greater than 8.5V DC.
With  the  exception  of AGM  and  gel  cell 
batteries,  all  other  battery  types  may  or 
may  not  have  vent  caps.  Vent  caps  are 
located on top of the battery and provide a 
means to add distilled water when needed
Batteries should be marked with their type. 
If charging a battery that is not marked, 
check  the  manual  of  the  item  that  uses 
the battery. If the battery type is unknown, 
use the REGULAR setting. Make sure the 
battery complies with the safety instructions 
on page 3.
CHARGE RATE SWITCH 
Use this switch button to set the maximum 
charge rate to one of the following.
•  2A SLOW CHARGE RATE: Intended for 
charging small batteries such as those 
commonly used in garden tractors, snow 
mobiles and motorcycles. The 2A rate 
is not intended to be used as a trickle 
charger for larger batteries.
• 
12A FAST   30A RAPID CHARGE 
RATE: Use for charging automotive bat-
teries, marine batteries, and deep cycle 
batteries.  Not  intended  for  industrial 
applications.
• 
75A START: Provides 75 amps for crank-
ing an engine with a weak or run down 
battery. Always use in combination with 
a battery.
NOTE:  To turn OFF the charger, unplug 
from the power cord from the wall outlet.
If the charge mode is changed after charg-
ing has started (by pressing the CHARGE 
RATE  or  BATTERY  TYPE  button),  the 
charging process will be restarted. 
The voltage displayed during charging is 
the charging voltage and usually will be 
higher than the battery’s resting voltage.