Husqvarna WS 462 用户手册

14 – 

English

In order for the saw to run stably and saw a straight cut, the 
four guide wheels must rest against the rail and not have too 
much play. When there is too much play between the saw 
carriage and rail the guide wheels must be adjusted:

The two marked guide wheels have eccentric axles and by 
turning these the carriage is tightened onto the rail.

Start by loosening the marked nuts (1) with the supplied 
special tool. Now loosen the two stop screws (2). When these 
are loose, adjust the guide wheels (3) against the rail by 
turning them towards the rail so the play is taken up. Hold the 
guide wheels and screw in the stop screw. Now screw on the 
nuts to secure the guide wheels in the new position.

As the saw wears, after a number of hours working, it can be 
a good idea to ensure that the saw sits firmly in the saw 
carriage and rail. If not, the handle probably needs adjusting:

Loosen the marked (1) socket headed screw (one on each 
side of the handle). Now turn the eccentric axles (2) with  the 
help of the supplied special tool until the axle lies tight against 
the saw. Now tighten the socket headed screw.