Husqvarna WS 462 用户手册

English

 – 15

After 100 hours of operation, the message "Time for 
servicing" is displayed.  The entire equipment shall then be 
taken to an authorized Husqvarna dealer for servicing. 

There is an oil plug for draining the oil located on the cutting 
arm. This plug should be cleaned when changing the oil. The 
new oil is filled through the hole where the oil plug sits.

The cutting arm contains 1 dl of Husqvarna Oil 150, a 
transmission oil of the type EP 150. The oil should be 
replaced for the first time in connection with the first service. 
A 1 dl bottle of oil is supplied when the machine is new.

There are two grease nipples on every saw unit.  Through 
these the gears for the feeding engines can be lubricated.  
Lubricate daily or at least every 30 hours of operation.  Use 
VEIDEC POWER LUBE or corresponding grease.

In order for the blade spindle to be fitted as easily as possible, 
it may be necessary to grease the hexagonal blade spindle. 
At the same time check that the hexagon is not damaged.

1

Check that all couplings, connections and hydraulic hoses 
are in full working order.

2

Clean the outside of the machine. Do not use a high 
pressure washer to clean the saw.

3

Check that the blade and th blade guard is not damaged 
or cracked. Replace the blade or the blade guard if it is 
exposed to impact or is cracked.

IMPORTANT! All types of repairs may only be carried out by 
authorised repairmen. This is so that the operators are not 
exposed to great risks.

IMPORTANT! Inspection and/or maintenance should be 
carried out with the motor switched off and the plug 
disconnected.

IMPORTANT! Used engine oil and transmission oil is 
hazardous to health and must not be disposed of in the 
ground or out of doors.