Ricoh 70eI92 用户手册

Pages have toner streaks

Clean the printer as described in Chapter 4.

Page is wrinkled or printed 
characters are blurred

• Paper does not meet specification.

- See 

• Moisture content is too high.

- Replace with newly unwrapped paper.

• The side guide is not adjusted properly.

- Adjust to proper size.

• OCP setting does not match loaded paper.

- Load the correct size paper

• Print density is too high.

- Contact your authorized Service Technician (Note 1)

Paper is streaked, spotted, 
or smudged (Note 2)

• The inside of the printer is dirty.

- Clean the inside of the Printer

• Print density is too high.

- Contact your authorized Service Technician (Note 1)

• Change of paper settings.

- Print a Cross Pattern test print to remove dirt.

• The Drum may be damaged.

- Replace the drum. (Note 2)

Voids or vertical voids

• Moisture content is too high.

- Replace with newly unwrapped paper.

• Paper does not meet specification.

• Creased or wrinkled paper is loaded in the tray.

- Removed damaged paper or replace with newly unwrapped paper.

• Print density is too high.

- Contact your authorized Service Technician (Note 1) 

• There may be condensation inside the printer.

- Turn on the printer power and leave it for 30-60 minutes, then start 
printing.

• The drum unit may be damaged.

- Replace the drum unit.

The tip or back end of paper 
is dirty

• Clean the NIP Guide and the TR Guide.

• Clean the Finisher Exit Roller.

Part of solid printing is 
scraped or scratched

• Print Density is too high

- Contact your authorized Service Technician (Note 1)

Printing is too dark

• Print Density is too high

- Contact your authorized Service Technician (Note 1) 

• Print Density is too high after initial power up.

- Contact your authorized Service Technician (Note 1)

Note 1: Print Density Adjustment is a Service Menu item and requires an Authorized Service Technician.
Note 2: A paper jam may cause staining of the fuser unit. Print several pages to remove the stain.