Xerox 5230A 用户手册

IPP (Internet Printing Protocol) 

271

The following computers support IPP.

NOTE: For Internet printing from a Windows Me computer, the IPP port should be 
installed. For the IPP port installation, see the Windows Me documentation.

Use the following procedure to install and use the machine in an IPP environment. 

There are three stages.

Network Communication Setup
The machine needs to be set up for IPP.

Computer Setup
The computer needs to be configured to submit print data to the machine.

Test Print
A print job should be submitted to make sure that the machine has been installed and 
configured correctly.

This section describes how to set up the network communication parameters for the 
machine.
At the machine, perform these steps.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP 
network.

NOTE: Some of the configuration options for this protocol are only available from 
CentreWare Internet Services. Refer to 

Initially, enable the IPP port.

Connect the machine to the network.

Press the <Log In/Out> button on the control panel, and then type the System 
Administrator login ID to enter the System Administration mode. 

NOTE: The passcode may also be required depending on the machine configuration.

Press the <Machine Status> button on the control panel, and then select the 
[Tools] tab on the screen. 

Select [System Settings] in the menu at the left side of the screen.

Select [Connectivity & Network Setup] in the [Group] menu.

IPP port

Windows 2000
Windows XP
Windows Server 2003
Windows Me
Windows Vista

TCP/IP