Xerox 480 ST 用户手册
Xerox Document Centre System Administration Guide
Page 11 - 5
11
. M
icr
os
o
ft
Windows
NT
4.X
11.
Mi
c
roso
ft
Wi
ndow
s
N
T
4.
X Serv
er N
e
tw
ork
Go to the workstation and...
NOTE
This procedure assumes that any TCP/IP components necessary for
network installation have already been assigned to the Document
Centre. If these components have not been configured, please refer
to the appropriate information contained within the section entitled
Dynamic/Static IP Addresses & WINS before continuing further.
network installation have already been assigned to the Document
Centre. If these components have not been configured, please refer
to the appropriate information contained within the section entitled
Dynamic/Static IP Addresses & WINS before continuing further.
1.
Verify that the TCP/IP protocol stack is loaded.
2.
Use the CentreWare Network Services CD-ROM to install
print drivers. Details for this are found in the document sup-
plied with your printer entitled CentreWare Network Ser-
vices Guide.
print drivers. Details for this are found in the document sup-
plied with your printer entitled CentreWare Network Ser-
vices Guide.
3.
Connect the printer that you just created to the shared
resource on the server.
resource on the server.
4.
Open an application on the workstation and print a test page
to verify operation.
to verify operation.
5.
Check your test job for quality and use the problem solving
section of the Document Centre 490/480/470/460 Refer-
ence Guide for resolving print defects.
section of the Document Centre 490/480/470/460 Refer-
ence Guide for resolving print defects.
6.
Repeat this Go to the workstation and... procedure for each
workstation on the network that will print to the printer.
workstation on the network that will print to the printer.