Xerox 480 ST 用户手册
Xerox Document Centre System Administration Guide
Page 12 - 1
12. OS
/2 (TC
P
/I
P
)
Net
w
or
ks
12.
O
S
/2
(
T
C
P
/I
P
)
Ne
tw
o
rk
s
12. OS/2 (TCP/IP) Networks
Before You Start
To enable 100BaseT or a Token Ring interface, refer to Chapter 2
How to Connect to Ethernet or Token Ring Networks to
configure the Speed and Source Routing settings for your
environment.
How to Connect to Ethernet or Token Ring Networks to
configure the Speed and Source Routing settings for your
environment.
NOTE
Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If your DHCP server will
provide host name, IP address, Gateway address, and Subnet Mask,
the Document Centre TCP/IP information will be configured on
initial boot. This means that if you have configured your DHCP
server with the desired information, you may go right to the
heading in this section entitled Go to a Workstation and....
the IP protocol enabled by default. If your DHCP server will
provide host name, IP address, Gateway address, and Subnet Mask,
the Document Centre TCP/IP information will be configured on
initial boot. This means that if you have configured your DHCP
server with the desired information, you may go right to the
heading in this section entitled Go to a Workstation and....
For information on how your printer can connect to a BOOTP
server, or a RARP server to be assigned an IP address dynamically,
refer to the section in this document entitled Dynamic/Static IP
Addresses & WINS. Information in regards to static IP address
configuration may be found within that section as well.
server, or a RARP server to be assigned an IP address dynamically,
refer to the section in this document entitled Dynamic/Static IP
Addresses & WINS. Information in regards to static IP address
configuration may be found within that section as well.