Omega Engineering OMB-1108-0901 用户手册
DaqTemp Series User’s Manual
08-27-02
CE-Compliance 5-3
CE Cable Kit for DaqTemps
CAUTION
CAUTION
CAUTION
CAUTION
Turn OFF the power to, and UNPLUG the host PC and externally connected equipment prior to
removing the PC’s cover and removing (or installing) the DaqTemp Series PCI Board. Electric
shock or damage to equipment can result even under low-voltage conditions.
removing the PC’s cover and removing (or installing) the DaqTemp Series PCI Board. Electric
shock or damage to equipment can result even under low-voltage conditions.
Take ESD precautions (packaging, proper handling, grounded wrist strap, etc.)
Use care to avoid touching board surfaces and onboard components. Only handle boards by their
edges (or ORBs, if applicable). Ensure boards do not come into contact with foreign elements such
as oils, water, and industrial particulate.
edges (or ORBs, if applicable). Ensure boards do not come into contact with foreign elements such
as oils, water, and industrial particulate.
Note: The part number of the CE Cable Kit that is used with DaqTemp Series Boards is CA-209.
By following these instructions correctly, your DaqTemp will be CE Compliant in accordance with the
conditions stated on your DaqTemp board’s Declaration of Conformity.
conditions stated on your DaqTemp board’s Declaration of Conformity.
If your board is already installed, you will need to remove it from the PC before proceeding. If your board
is not yet installed, proceed to the section entitled Install the CE ORB.
is not yet installed, proceed to the section entitled Install the CE ORB.
Remove the DaqTemp Series Board from the Host PC
1. Turn the host PC’s power OFF.
2. Turn power OFF to externally connected equipment.
3. UNPLUG the host PC and all externally connected equipment.
4. Remove the PC’s cover. Refer to your PC Owner’s Manual as needed.
5. Locate the DaqTemp PCI Board and carefully remove it from the PCI slot.
2. Turn power OFF to externally connected equipment.
3. UNPLUG the host PC and all externally connected equipment.
4. Remove the PC’s cover. Refer to your PC Owner’s Manual as needed.
5. Locate the DaqTemp PCI Board and carefully remove it from the PCI slot.
Install the CE ORB
1. Remove the two screws that secure the standard [non-CE] ORB to the board (see following figures).
2. Using the same screws, mount the CE ORB to the board. Tighten the screws snug, but do not over
tighten.
Mounting a DaqTemp Series PCI Board to a CE ORB