TANDBERG D50104-15 用户手册

Health Care System III

23

Installation

3) Feed the power cord down into the post and out to the power bar. Plug the power cord into the cart’s

isolated power bar.

4) Re-install the cable entry cover and the back panel on the cart.

Connect the VCR cables to VCR on the rear interface panel as follows:

1) Connect a video cable between Video Out on the VCR and VCR VIDEO IN.

2) Connect a video cable between Video In on the VCR and VCR VIDEO OUT.

3) Connect an audio cable between Audio Out on the VCR and VCR AUDIO IN.

4) Connect an audio cable between Audio In on the VCR and VCR AUDIO OUT.

For playback operation, press  

vcr

 on the remote control.

Make sure that ‘Audio6 (VCR)’ is ‘On’ (see ‘Inputs’ in the ‘Audio Settings’ menu). If the audio
from the VCR is too low, the level can be adjusted in ‘Level Settings’ in ‘Audio Settings’,
‘Inputs’.

The audio from the VCR will be sent to the other side and to the local speaker system.

For most VCRs, the default audio output settings will be set correctly. If adjustments are required, see section
‘Level Stettings’ in ‘Outputs’, ‘Audio Settings’.

• 1 video output signal through a S-Video connector (Video Out 2 on Codec).

• 1 video output  signal through a BNC connector (Video Out 4 on Codec).

• 1 audio output (line level) via an RCA connector (LOOP OUT on speaker module).

U

SE

 

CABLE

 

TIES

 

TO

 

NEATLY

 

SECURE

 

AND

 

STOW

 

CABLES

 

WHEN

 

REQUIRED

.

 I

F

 

DUAL

 

MONITOR

 

SETTINGS

 

IS

 

SET

 

TO

 VGA, 

NO

 

OUTPUT

 

WILL

 

BE

 

SEEN

 

FROM

 

THE

 D

UAL

 

VIDEO

 

CONNECTORS

.

The format of the video output will be either PAL or NTSC depending on your country’s standard video
format.

Any equipment that is connected to Dual must be powered from either the cart’s internal
isolated power bar or an external isolated transformer, as per the requirements indicated on
pages 4 and 5 under Warning.