TANDBERG D50104-15 用户手册

Health Care System III

25

Installation

2) Place the PC on the shelf close to the back, leaving only enough room for the cables between the PC and

the rear panel of the cart.

3) Place the keyboard and mouse on their respective shelves and route their cables from the rear of the

keyboard shelf to the cart post. Remove the cable entry cover from the post and feed the cables down
into the post and out to the PC. Plug the keyboard and mouse cables into their respective connectors on
the PC. Re-install the cable entry cover on the post.

U

SE

 

CABLE

 

TIES

 

TO

 

NEATLY

 

SECURE

 

AND

 

STOW

 

CABLES

 

WHEN

 

REQUIRED

.

4) Connect the four cables that are permanently installed on the cart to the PC as follows:

Remove the terminator labelled S-VIDEO TERMINATOR from the cable connector labelled
PC S-VID IN and connect the cable to the ‘S’ video input on the PC.

Connect an additional microphone as required, to this connector. By default, this input is active.

To install a PC on the cart, proceed as follows.

1) Remove the back panel from the cart’s PC shelf by removing the two screws on the panel’s bottom

corners, and then removing the two screws on the panel top.

I

F

 

THE

 PC 

IS

 

EVER

 

REMOVED

 

OR

 

DISCONNECTED

, 

THE

 S-V

IDEO

 

TERMINATOR

 

MUST

 

BE

 

RECONNECTED

 

TO

 

THE

 PC S-VID IN 

CABLE

.

Connect the cable labelled PC VGA OUT to the monitor output connector on the PC.

Connect the cable labelled PC COM PORT to the RS-232 communication connector on the PC.

Connect the cable labelled PC AUD OUT to the audio output connector on the PC.

5) Connect the power cable (supplied with PC) from the PC to the power bar at the rear of the PC shelf.

6) Re-install the back panel on the cart.

Remove the microphone from its shipping box (stored in utility drawer), and connect it to its receptacle on
top of the monitor. Snap the body (black area) of the microphone into the mounting adapter. Ensure that the
low frequency cutoff switch is in the normal position indicated by “ - ”. Slip the windscreen fully onto the
microphone, and adjust the microphone direction as necessary.

Adding an external microphone to the HCS III:

1)

Place the table microphone on a flat surface or table.

2)

Plug the microphone into the microphone connector labelled as Mic 3 at the back of the HCS III cart.