National Instruments AT 用户手册
Chapter 4
PCMCIA Serial Hardware Installation, Verification, and Configuration
© National Instruments Corporation
4-19
If the diagnostic test completes with no failures, your serial hardware and
software are installed properly. If it fails, refer to Appendix D,
software are installed properly. If it fails, refer to Appendix D,
, for troubleshooting instructions.
After you verify the hardware and software installation, connect the cables.
See Appendix A,
See Appendix A,
, for information about cable
connections.
Configure Communication Port Settings
The serial configuration utility is fully integrated with the Windows NT
Control Panel. You can use it to examine or modify the configuration of the
serial port.
Control Panel. You can use it to examine or modify the configuration of the
serial port.
Follow these steps to configure the serial port.
1.
Select Start»Settings»Control Panel and double-click on the niports
icon. A list of National Instruments ports appears, as shown in
Figure 4-10.
icon. A list of National Instruments ports appears, as shown in
Figure 4-10.
Figure 4-10. niports Configuration Utility
2.
Select the port you are interested in.
3.
Click on the Settings button to view or configure the port settings.
Refer to the next section,
Refer to the next section,
, for more information.
4.
Click on the Resources button in the General Port Settings dialog
box to view or configure the resources for the port. Refer to the
box to view or configure the resources for the port. Refer to the
section, for more information.