National Instruments AT 用户手册
Chapter 4
PCMCIA Serial Hardware Installation, Verification, and Configuration
4-20
ni.com
5.
Click on Delete to remove hardware information about the port from
Windows NT. You should do this before you physically remove your
PCMCIA card.
Windows NT. You should do this before you physically remove your
PCMCIA card.
6.
Click on Add to configure resources for a new PCMCIA card.
General Port Settings
This section describes the options you can set in the General Port Settings
dialog box, shown in Figure 4-11.
dialog box, shown in Figure 4-11.
Figure 4-11. General Port Settings Dialog Box
COM Port Number
You can use the COM Port Number control to change the COMx name of
the port selected.
the port selected.
Transceiver Mode
The transceiver mode selection shows the transceiver mode in use, and
applies only to PCMCIA-485 cards. Refer to Chapter 6,
applies only to PCMCIA-485 cards. Refer to Chapter 6,
, for more information about transceiver modes. If you use
two-wire TXRDY mode, FIFOs must be enabled.