Baldor EXB009A01 用户手册
3-2 Installation
1-15HP Size A and B Controls
(For all 15H Inverter, 18H Vector, and 23H Servo).
Single Expansion Board Installation
Procedure:
1.
Be sure drive operation is terminated and secured.
2.
Remove all power sources from the control.
3.
Wait at least 5 minutes for internal capacitors to discharge.
4.
Remove the four (4) Phillips head screws that secure the
control cover.
control cover.
5.
Remove the control cover.
6.
Remove the #6 screw at position MH1 (upper left on the
main circuit board. See Figure 3-1.
main circuit board. See Figure 3-1.
7.
Install the long standoffs provided in the installation
hardware as shown in Figure 3-1. (Be sure the
Male/Female standoff is at position MH1. The other three
are Female/Female.)
hardware as shown in Figure 3-1. (Be sure the
Male/Female standoff is at position MH1. The other three
are Female/Female.)
8.
Slide the expansion board male connector into the female
connector of the control board.
connector of the control board.
9.
Securely mount the expansion board to the standoffs
installed in step 7 using #6 screws provided in the
installation hardware. See Figure 3-2.
installed in step 7 using #6 screws provided in the
installation hardware. See Figure 3-2.
10. The mechanical installation of the expansion board is now
complete. Refer to Section 4 of this manual and configure
the jumpers as desired. Also complete the wiring before
you proceed to step 11.
the jumpers as desired. Also complete the wiring before
you proceed to step 11.
11. When complete, install the control cover using the four (4)
Phillips head screws.
12. Restore all power sources to the control.
13. Restore drive operation.