Sun Microsystems 60 用户手册

3-4

Sun Ultra 60 Service Manual • August 2001

4. In a shell window on the Sun workstation, type

tip hardwire

Note –

The shell window is now a tip window directed to the serial port of the

system unit being tested. When power is applied to the system unit being tested,
POST messages will be displayed in this window.

5. When POST is completed, disconnect the tip window as follows:

a. Open a shell window.

b. Type

ps -a

to view the active tip line and process ID (PID) number.

c. Type the following to kill the tip hardwire process.

3.2.2

Verifying the Baud Rate

To verify the baud rate between the system unit being tested and a terminal or
another Sun workstation monitor:

1. Open a Shell window.

2. Type

eeprom.

3. Verify the following serial port default settings as follows:

Note –

Ensure that the settings are consistent with TTY-type terminal or

workstation monitor settings.

hostname% tip hardwire

connected

% kill -9 PID#

ttyb-mode = 9600,8,n,1

ttya-mode = 9600,8,n,1