Lucent Technologies R5SI 用户手册

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-320

reset interface 

If the standby SPE is not refreshed when this command is executed, then the 
following message is displayed:

Standby SPE memory not refreshed; use the 

"refresh spe-standby" command.

If the standby SPE is not refreshed and the active SPE is hard selected via the 
SPE select switches when this command is executed, then the following 
message is displayed:

Active SPE locked via select switches; 

Standby SPE memory not refreshed

If the standby SPE is busy with another task, then the following message is 
displayed:

Standby SPE busy with another task; 

for information use "status system 1"

If the standby SPE is not available when this command is executed, then the 
following message is displayed:

Standby SPE not available;

for information use "status system 1"

If during the execution of a command a resource problem occurs that requires 
the user to restart the command, then the following message will be displayed:

Command resources busy; 

Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the 
following message will be displayed:

All maintenance resources busy; try again later

If the reset interface command is successful, the following message will be 
displayed on the SAT:

Command successfully completed

If the reset interface command is unsuccessful, the following message will be 
displayed:

Error encountered, can’t complete request

None.