Lucent Technologies R5SI 用户手册

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-319

reset interface 

If you press 

HELP

 after entering "reset interface," the following message displays:

Enter identifier: [cabinet(1)];carrier(A-B);position(1-2)

If the specified carrier is not the active PE, the following message will be 
displayed:

Command must be executed from active SPE

If the technician-entered cabinet and carrier is invalid for a PPN, the following 
message will be displayed:

Invalid port-network specified

If the technician-entered carrier is not a valid carrier, the following message will 
be displayed:

Invalid carrier specified

If the technician-entered carrier is not active, the following message displays:

Board invalid

If the specified carrier/position processor interface circuit pack is not inserted, 
but the specified carrier is active, the following error message will be displayed:

Processor Interface (TN765)

not started or is being started

If the command entered is in conflict with another currently executing command, 
then a message will be displayed showing the login id of the conflicting user and 
the conflicting command. The message is as follows:

’login id’:’command’ has a command conflict

If the standby is entering maintenance mode when this command is executed, 
then the following message is displayed:

Cannot interrupt Standby SPE while entering 

maintenance mode; please try later

location

The location (cabinet-carrier-position) of the processor interface (PI 
board). The position determines which processor interface circuit pack 
will be cleared. A position of 1 is the first processor interface in the 
carrier, while a position of 2 is the second processor interface in the 
carrier.