AMCC 9590SE-4ME 用户手册
Chapter 2. CLI Syntax Reference
46
3ware Serial ATA RAID Controller CLI Guide for the Power Mac G5
/c
x
add verify=
ddd:hh:duration
This command adds a new background verify task to be executed on the day
ddd (where ddd is Sun, Mon, Tue, Wed, Thu, Fri, and Sat), at hour hh
(range 0 .. 23), for a duration of duration (range 1 .. 24) hours. A maximum of
seven verify tasks can be scheduled. This command will fail if no (empty)
task slot is available.
ddd (where ddd is Sun, Mon, Tue, Wed, Thu, Fri, and Sat), at hour hh
(range 0 .. 23), for a duration of duration (range 1 .. 24) hours. A maximum of
seven verify tasks can be scheduled. This command will fail if no (empty)
task slot is available.
Example:
//localhost> /c1 add verify=Sun:16:3
adds a verify background task schedule to be executed on Sundays at 16
hours (4:00 PM) for a duration of 3 hours.
hours (4:00 PM) for a duration of 3 hours.
Setting Up a Verify Schedule
Setting up a verify schedule requires several steps, and several different CLI
commands in addition to /cx add verify.
commands in addition to /cx add verify.
To set up the verify schedule you want to use, follow this
process:
process:
1
Use the /cx show verify command to display the current schedule for
verify tasks. (For details, see page 43.)
verify tasks. (For details, see page 43.)
2
If any of the scheduled tasks do not match your desired schedule, use
the /cx del verify command to remove them. (For details, see page 48.)
the /cx del verify command to remove them. (For details, see page 48.)
3
Use the /cx add verify command to create the verify schedule slots you
want (described above.)
want (described above.)
4
Use the /cx set verify=enable command to enable the schedule (this
enables all rebuild schedule slots). (For details, see page 49.)
enables all rebuild schedule slots). (For details, see page 49.)
5
Use the /cx/ux set autoverify=on command to turn on autoverify for each
unit you want to follow the schedule. (For details, see page 61.)
unit you want to follow the schedule. (For details, see page 61.)
Note:
If you do not enable autoverify for units or start a verification manually, your
verify schedule will not run, even if it is enabled with the
/cx set verify=enable command.
/cx set verify=enable command.
Warning:
If all time slots are removed, be sure to also disable the schedule.
Otherwise the applicable background task will never occur