Q-Logic 8100 SERIES 用户手册

C–Brocade CEE/FCoE Switch/Blade Configuration

Create and Configure FCoE VLAN

FE0254601-00 A

C-3

To create and configure the FCoE VLAN:

1.

Enter the CEE management shell, and move to the global configuration 
mode by issuing the following commands:

admin> cmsh
# configure terminal

admin> cmsh
# configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
(config)#

2.

Create the VLAN interface 1002 by issuing the following command:

(config)# interface vlan 1002

For QLogic Converged Network Adapters, use only VLAN 1002 to enable 
FCF forwarding.

3.

Enable the forwarding of FCoE traffic on VLAN 1002 by issuing the following 
command:

(conf-if-vl-1002)# fcf forward

4.

Verify the VLAN configuration by issuing the following command:

(conf-if-vl-1002)# do show vlan brief

VLAN     Name            State   Ports
                                 (u)-Untagged, (t)-Tagged
                                 (c)-Converged
======= ================ ======= ===============================
1       default          ACTIVE  
                                 
1002    VLAN1002         ACTIVE  

There are no ports/interfaces under VLAN 1002.

5.

Exit VLAN configuration mode by issuing the following command:

swd77(conf-if-vl-1002)# exit