Motorola CPCI-6020 用户手册

Refer to the following illustration and perform these steps when installing modules. Note that 
this illustration is for general reference only and may not accurately depict the connectors and 
handles on the board you are installing.

1. Open the injector levers on your board (see 

2. Verify the proper slot for the module you are inserting (see 

). Align the edges of the module with the card cage rail guides in the 

appropriate slot. Insert the board by holding the injector levers, do not exert 
unnecessary pressure on the face plate.

3. Using your thumbs, apply equal and steady pressure as necessary to carefully slide 

the module into the card cage rail guides (Stage 1). Continue to gently push until the 
prealignment guide pegs engage with the backplane connector (Stage 2) and the 
injector levers make contact with the chassis rails. Do not force the board into the 
backplane slot. 

4. Use the injector levers to seat the module in the slot by closing the levers until they 

latch into the locked position (Stage 3). If the levers do not completely latch, remove 
the module from the chassis and visually inspect the slot to ensure there are no bent 
pins.

5. When the module you are installing is completely latched, secure it by tightening the 

captive screws at both ends of the face plate.

This section describes a recommended procedure for removing a board module from a chassis.

J5

J4

J3

J2

J1

Stage 2

(Detail)

J5

J4

J3

J2

J1

Stage 1

Stage 3

Stage 2

P5

P4

P3

P1

P2

P5

P4

P3

P1

P2