Asrock P4S61 用户手册

1 4

2.8 Connectors

Connectors are NOT jumpers. DO NOT place jumper caps over

these connectors.

Connector

Figure

Description

FDD connector

(33-pin FLOPPY1)

(see p.7 item 15)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

Secondary IDE connector (Black)

(39-pin IDE1, see p.7 item 9)

(39-pin IDE2, see p.7 item 8)

Note: If you use only one IDE device on this motherboard, please set the IDE

device as “Master”. Please refer to the instruction of your IDE device

vendor for the details. Besides, to optimize compatibility and performance,

please connect your hard disk drive to the primary IDE connector (IDE1,

blue) and CD-ROM to the secondary IDE connector (IDE2, black).

USB 2.0 connector

ASRock I/O

provides you 4

(9-pin USB45)

default USB 2.0 ports on the

(see p.7 item 19)

rear panel. If the rear USB 2.0

ports are not sufficient, this

USB 2.0 connector is available

to support 2 additional

USB 2.0 ports.

Infrared module connector

This connector supports an

(5-pin IR1)

optional wireless transmitting

(see p.7 item 16)

and receiving infrared module.

FLOPPY1

Pin1

IDE1

PIN1

IDE2

PIN1

DUMMY

GND

+5V

IRTX

IRRX

USB_PWR

P+5

P-5

P+4

P-4

GND

DUMMY

connect the black end

to the IDE devices

connect the blue end

to the motherboard

80-conductor ATA 66/100/133 cable

the red-striped side to Pin1